_________________________________________________________________________________________________________________________
REV. 7-29-15 Page 2 of 4
Model: 4001 & RCKIT4001
INSTALLATION INSTRUCTIONS
WARNING
This remote control system must be installed exactly as outlined in these instructions. Read all instructions completely before
attempting installation. Follow instructions carefully during installation. Any modifications of the remote control or any of its components
will void the warrant and may be pose a fire hazard.
Do not connect any gas valve or electronic module directly to 110-120VAC power. Consult gas appliance manufacturer’s instructions
and wiring schematics for proper placement of all wires. All electronic modules are to be wired to manufacturer’s specifications.
The following wiring diagrams are for illustration purpose only. Follow instructions from manufacturer of gas valve and/or electronic
module for correct wiring procedures. Improper installation of electric components can cause damage to electronic module, gas valve
and remote receiver.
INSTALLATION
The remote receiver can be either wall-mounted in a standard plastic switch box or placed on or near the fireplace hearth. Preferably,
the remote receiver should be wall-mounted in a plastic switch box. When locating the receiver at the hearth PROTECTION FROM
EXTREME HEAT IS VERY IMPORTANT. Like any piece of electronic equipment, the remote receiver should be kept away from
temperatures exceeding 130
0
F inside the receiver case. Battery life is also significantly shortened if batteries are exposed to high
temperatures.
Make sure the remote receiver switch is in the OFF position. It is recommended that 18 gauge solid or stranded wires (included) be
used to make connections between the terminal wiring block on the millivolt gas valve or electronic module and the wire terminals on
the remote receiver. For the best results use wire with no splices and measuring no longer than 20 ft.
WALL MOUNTING
Install (4) AA-size 1.5 ALKALINE batteries in the remote receiver. For best performance, remote receiver batteries should be factory
fresh when installed. Very little battery power is required to operate the remote receiver, but the electronics are tuned to operate best
when battery output is greater than 5.3 volts. Four new AA batteries should provide an output voltage of 6.0 to 6.2 volts.
Be sure
batteries are installed with the (+) and (-) ends facing the correct direction
.
To attach Cover Plate to Receiver box
Position the receiver as shown in diagram to the left with lower
tab on cover plate inserted into groove of receiver make sure
the cover plate properly aligns with remote receiver. Pull Receiver
up and snap into top tab of cover plate.
Position the cover plate so the word ON is facing up; then, install
the remote receiver into the plastic switch box using the two long
screws provided. Push the White Button over the receiver slide
switch. Make sure the remote receiver code switches has been set
to match the transmitter code switches before completing the
installation
Note
: Code setting section on page 4.
NOTE
: The remote receiver will only respond to the transmitter when the 3-position slide button on the remote receiver is in the
REMOTE position. If the system does not respond to the battery transmitter on initial use, see CODE SETTING SECTION,
and recheck battery positions in the remote receiver
.
HEARTH MOUNT
The remote receiver can be placed on the fireplace hearth or under the fireplace, behind the
control access panel. Position where the ambient temperature inside the receiver case does
not exceed 130
0
F
. Battery life is also significantly shortened if batteries are exposed
to high temperatures. Make sure the remote receiver code switches have been set to
match the transmitter code switches before completing the installation
Note
: Code setting section
.
NOTE
: Black Slide Button is used for Hearth Mount applications.
Remote Receiver
Cover Plate
(Rear View)
WALL
Plastic Switch Box
Remote Receiver
Cover Plate
Receiver
Slide
Button
OFF
REMOTE
ON
OFF
ON
R
E
M
O
T
E
Wire terminals
Remote Receiver
REMOTE
ON
OFF
Code Switches
Slide Button
