iHome SMARTDESIGN iC16 series, Инструкция по эксплуатации

Страница: 9 / 14

6
Note: In order for the alarm to operate you must install the 4 "AA" batteries or have the AC adaptor
connected. The CR2032 back up battery will maintain the time and alarm settings but it will not turn
on the alarm.
This unit features Gentle Waking, which gradually increases the volume of the alarm.
Setting the Alarm
1. Press and hold the Button until the hour display flashes. Press the or Button until the
desired alarm hour is displayed. Remember to set the correct AM or PM time, indicated by PM on
the display; there is no AM indicator.
2. Press the Button again, then press the or Button until the desired alarm minute is
displayed.
3. Press the Button again to exit the setting mode. You should hear 2 beeps indicating the alarm
is set.
Note: Once you set the alarm time, the alarm will be automatically armed, indicated by the icon.
To disarm the alarm, press the
Button . The icon will disappear and the alarm will not sound at
the set time.
Note: Make sure to adjust volume level for a comfortable wake up volume.
4. When the alarm is sounding, the icon will flash.
• To snooze during the alarm, press the
Snooze/Dimmer Button . The alarm will be silenced for 9
minutes, then come on again.
• To turn the alarm off and reset it to come on the next day, press the
Button
.
5. If the alarm is not turned off once it sounds, it will play for one hour then turn off automatically.
This cycle will repeat every 24 hours unless the controls are changed.
Alarm Operation