1. Unplug the hardwired aux audio cable from the cable cap on the back of the unit and connect it to the headphone jack
or aux-out jack on your audio device.
Press and release the
presets
Button
to play it. NOTE: Some aux devices will not respond to the iHM28 play/pause
command. Make sure to test how your device responds.
2. Navigate tracks and menus from your audio device.
3. When the device is in play mode, press the
presets
Button
to pause play; press again to resume play.
4. Press the or
Button
to adjust the unit volume.
5. To turn off the unit, press and release the
Button
. Make sure to turn off your audio device, too.
Playing your Aux Audio Device
A USB port is located on the back of the unit for charging devices while the unit is connected to AC power.
Connect one end of a compatible USB cable (not included) into the standard USB port on the unit and the other end into the
device you wish to charge. Some devices require proprietary USB charging ports or cables. Monitor the charging status of
your device. If the device does not charge, you will need to use the charger that came with your device.
6
Different regions of the world use different FM radio frequency steps and ranges. You will need to select the one that matches
the standards in your region (USA, EUROPE, JAPAN, AUSTRALIA, or CHINA). The default setting is USA; if you live in the US,
you may skip this section.
1. Make sure the unit is OFF (not playing in any mode). Press and hold the
radio/aux Button
for about 5 seconds until
“Radio xxx” appears in the lower part of display and 1 beep sounds. Press and release the
+
or
– Button
to set the “xxx”
to your region.
2. Press and release the
radio/aux Button
again (or no button within 10 seconds) to exit the radio frequency setting mode.
Two beeps will confirm radio frequency setting.
Using the Unit in Other Countries
Page 9
Charging a Device with the USB Port
