iHelmet (Model: LTD200S) User Manual
20 / 28
2) The device cannot work when charging.
5 Maintenance
5.1Cleaning Instructions
Clean the inside of the iHelmet (the side where the lasers reside) with a soft, dry cloth after
using. Do not use any abrasive cloths. Do not use any chemicals such as acetone, soap or
detergents. Do not submerge in water.
Please checks the device normally on/off before every use.
Warning
:
1) DO NOT use Acetone or any other cleaning agents on the iHelmet. Acetone and
other cleaning agents will damage the unit causing the warranty to be voided.
2) Always disconnect the iHelmet hair growth system from its power source before
attempting to clean it. Before cleaning your device, make sure that it is turned off.
3) Before operation, volatilize the cleaning solvent and flammable solution used for the
device.
5.2 Maintaining Your Device
The iHelmet is engineered to operate for many years when cared for properly. If you must
clean the device, please see above for cleaning instructions.
Warning
: Do not attempt to repair or service the iHelmet at home. If any
problems arise that may require service, contact Slinph immediately.
-
a schedule of maintenance necessary to keep the product in compliance; for example
：
Inspect optical output power at least once a year; inform supplier to change the light
source if there is obvious power decline.
5.3 Storing Your Device
Keep your iHelmet stored in a dry place with a temperature range between -20 to 65 degrees
Celsius. This device stored in an area with the humidity that is 30% to 80%. Keep your iHelmet
out of direct sunlight and away from hot surfaces or devices that emit heat. The iHelmet cannot
be kept in close proximity to chemicals of any kind.
