Using the Operator Settings
38
4.3.5 Connection Test
After you have assigned a group number for the cabinets to be connected and
set up the ID, you can enter the page of
[Connection Test]
to test whether each
cabinet of the same group is normally connected.
❶
Enter
[Operator Settings] > [Hardware Test] > [Connection Test]
.
❷
In the page of
[Connection Test]
, press the button, and the system will start
sending the connection status of all cabinets. Possible connection status
includes:
Connected
、
Checking
、
Connection failed
❸
After the testing is completed, press the button again to return to the previous
menu.
Notes:
No matter how many cabinets are connected, the system will automatically
run the testing for four cabinets (1P~4P). If only two cabinets are
connected (such as 1P and 2P), the system will still display connection
failure for 3P and 4P, then you can simply ignore this message.
When the connection could not be built:
1.Check if internet wires are correctly plugged in.
2.Regarding cabinets to be connected, enter
[Operator Settings] >
[System Setting] > [Connection Setting]
and check if all cabinets are
appointed to the same group but a different ID.
Hardware Test
Содержание Speed Rider 3
Страница 11: ...Introduction of the Cabinet 10 An overview of the cabinet Viewed from the Top and back 2121 mm...
Страница 33: ...Using the Operator Settings 32 Operator settings default list Menu Structure...
Страница 86: ...Appendix 1 warning labels of the cabinet warning labels of the cabinet 85...
