Ignite B6A800101, Руководство по эксплуатации и техническому обслуживанию

Страница: 15 / 44

13
storage when the gutter brush is in the lowered
position.
NOTE: Your attachment model kit may vary, but the
procedure is the same.
Figure 10
C208360a
5. Pull the knob (Item 1) [Figure 10] into the ON
position.
The gutter brush will start to turn with the sweeper
brush when the auxiliary hydraulics are engaged.
Figure 11
C210208a
6. The gutter brush is designed to sweep debris from a
curb or gutter out in front of the sweeper with the
sweeper in a forward travel direction [Figure 11].
NOTE: If the sweeper is used in the reverse mode
(scraping / sweeping) for any length of time, the
gutter brush should be turned off and lifted to the
transport position or removed from the sweeper.
OPERATING PROCEDURE WITH LOADERS
Approved Models And Requirements
Sweeper 72”
Hydraulic Flow 15.9 – 30.4 gal/min
Hydraulic Pressure
Range/Max 2466 – 3481 PSI
The chart shows the approved sweeper model for
machines based on hydraulic flow and pressure.
Warranty on this attachment is void if used on a non-
approved carrier. Contact your Ignite Attachments
representative for a current list of approved carriers.
WARNING
MODIFICATION AND INSUFFICIENT INSTRUCTIONS
HAZARD
Use of unapproved attachments / implements or
improperly sized attachments / implements can
cause serious injury or death.
Attachments / implements and buckets for safe loads
of specified densities are approved for each model.
Never use attachments / implements or buckets
which are not approved by .
◂
W-2709
Machine / Attachment Setup
Removable Hose Guide (If Equipped)
Figure 12
C213364a
Some attachments are factory equipped with a
removable hose guide (Item 1) [Figure 12] installed on
the hydraulic hoses. The removable hose guide is factory
installed for use with machines equipped with a mounting
post (Item 1) [Figure 13].
OPERATING INSTRUCTIONS