IGM LAGUNA Fusion3Dro, Руководство по эксплуатации

Страница: 10 / 22

-10- www.igmtools.com
and nuts to the short rear fence guide and
the back left of the table. STOP BEFORE
TIGHTENING: Keep bolts loose until entire rail
assembly is in place to properly level rail.
2. Attach short rear fence support
Repeat step 1 for the longer rear fence section
with (3) bolts, lock washers, washers, and nuts.
Use the same assembly diagram in Step 1.
NOTICE: If the fence hooks are not yet
installed, now is a good time to do so.
3. Attach short rear fence support
To level the rear fence with the table top,
place a rigid straight edge on top of the rails.
Apply downward force at both arrow indicators
and simultaneously tighten the bolts with the
supplied Allen key and wrench.
4. Attach T-slot bolts to front table
Loosely fasten the (5) square headed bolts, (5)
washers, and (5) nuts. A couple revolutions of
the bolt will be tight enough. Prepare to insert
the (2) aluminium front rail sections.
5.Insert the long front fence support
Insert the long Front Rail. STOP BEFORE
TIGHTENING: Keep these bolts loose until the
entire rail assembly is in place to properly level
the rail.
6. Insert short rail and switch
Insert the short front rail into the first square
head bolt. IMPORTANT: Insert the switch
assembly before joining the two front rail
pieces. STOP BEFORE TIGHTENING.
7. Join front fence supports
Align the pins and join the two front rail pieces
and firmly push together.
8. Align the front rail with blade
Using the blade notching on the measuring
tape, align the entire front rail section to the
blade.
9. Level and fasten front rail
To level the front rail sections to the table top,
use a ridged straight edge atop the loosely
fit rail sections. Apply downward force to the
straight edge while keeping the two sections
firmly together. Simultaneously fasten down the
bolts.
10. Install the fence
Install the fence by placing the front end
first. Be sure that the handle is in the open,
unlocked, position prior to installing.
11. Level the table saw with casters and fix
Level the table saw with the ground and fix the
machine on the floor with screws.
6.5 Installing/removing the throat plate
1. Unplug the table saw!
2. Insert the throat plate back end first.
3. Lower the throat plate to the table.
4. Lock the throat plate with the thumb-lock.
5. Level the throat plate with the table using
the cat screws.
Note: This machine is shipped with a zero-
clearance throat plate that has already been
cut at the factory. Because of this, there may be
some residue already in the saw.
Installing the throat plate
WARNING: MAKE SURE SAW IS
UNPLUGGED. To remove or install the throat
plate, first set it to the unlock position. Then,
insert the rear end first and tilt the other end
down into position.
Levelling the throat plate
Pic. 34
To level the throat plate, adjust the leveling
screws.
Note: Make sure the throat plate is lower than
the cast iron table. Having the throat plate
higher at any position can interfere with the
workpiece feed and cause injury or harm and
increase the chance of kickback
6.6 Installing/removing safety accessories
A: Saw blade
B: Riving knife housing
C: Cam action lever
D: Riving knife
E: Blade guard
F: Blade compliant markings