-
8
-
www.igmtools.com
pic.14
7. OPERATING THE MACHINE
7.1 Edgebanding
- Check for debris or dust in the glue pot, turn on
the main switch and trigger the heating next to the
display. The button on the handle (2) will light up when
the temperature reaches 120°C, press the button (1)
to accelerate the melting process. Make sure the glue
is properly stirred up before working. Turn the feed
off and place the tape on the infeed roller. Place the
support table on the workpiece and hold the machine
firmly with both hands (2), (3). Place the pressure roller
approximately 5 cm from the workpiece.
Turn the feed on (1), and wait for the tape to reach
the pressure roller. Press the tape to the workpiece
using the pressure roller. Then allow the machine to
run at its feed speed and only check the proper feed of
the tape.
How to switch between °C a °F
When the light is on, the temperature
is in °C and feed speed in m/min.
When the light is on, the temperature
is in °F and the feed speed is in Ft./min.
Heating switch; After turning on the
main power switch, turn on the heating
switch to begin heating the glue.
The glue is being heated when the
light is on.
Temperature setup; The temperature
changes by one degree after pressing
the button once
Quick set-up: by holding the button
for 3 seconds, you will hear a beep
and the temperature set-up will rise
quickly.
1
2
3
4
5
2
1
3
5
2
6
8
4
7
9
The display shows the current
temperature in the glue pot
Operating indicator light: lights up
when the temperature is over 120 °C
(250 F), you can speed up the heating
by turning on the tape feeder.
Speed indicator
Safe storage light:
When you turn off the heating, this light
will light up. And will go out when the
temperature in the glue pot goes below
60 °C (140 F). Now you can safely store
your machine in the carry bag.
7
8
9
6
Operating instructions EN
