IGM Professional FD300, Руководство по эксплуатации

Страница: 8 / 40

8
www.igmtools.com
Operating instructions EN
Workpiece width
This 12,7mm (½”) half blind template can be used with stock from 21,5mm (7/8”) to 305mm (12”) wide with
FD300 or to 610mm (24”) wide with FD600 . Pitch 21,5mm(7/8“) with 3mm offset line x no.of tails = ideal stock
width.
For symmetrical pin placement, use this table as a guide:
#of Whole Tails: 1 2 3 4 5 6 7 8
Ideal stock
tails
mm 21,5 43 64,5 86 107,5 129 150,5 172
inch 7/8“ 1-11/16“ 2-1/2“ 3-3/8“ 4-1/4“ 5-1/6“ 5-15/16“ 6-3/4“
SET UP
- Attach edge guides to the jig in the positions listed in the table above.
- Place X workpiece into front clamp bar. Tighten front clamp knobs.
- Place Y workpiece into top clamp bar.
- Push Y workpiece tightly against the edge guide and workpiece X. Tighten top clamp knobs.
- Retighten X workpiece, so that the top of front X workpiece is flush with the top of workpiece Y and snugly
against edge guide.
- Tighten front clamp knobs .
- Adjust template position to align the setting line with the edge of the workpiece under the top clamp. One
rotation of template adjustment nut stop equals 1mm.
- Tighten template assembly knobs.
- Attach the template guide to the router base.
- Install the dovetail bit in the router.
- Adjust the cutting depth of the dovetail bit according to table.
Note : Recommended bit depths are approximate only, always make test cuts in scrap stock to determine the
exact depth for your application!
Caution!
- Ensure that both workpieces are clamped securely and that they touch the edge guides.
- Always clamp only one set of workpieces . Ensure that the router bit does not touch the template
brackets before and after cutting the joint.
- Do not overtighten the knobs.
- Tighten or loosen the joint by increasing or decreasing cutting depth of dovetail bit.
- EN 5 -
24
25
26