Igloo MONIKA 2, Руководство пользователя

Страница: 17 / 40

en
17
User manual Monika 2, Rota www.igloo.pl
It is essential to keep the condenser of the device cle-
an. Dirt may hinder the heat exchange, causing mainly
increase in electric energy consumption and may cause
damage of aggregate compressor.
In order to clean the condenser it is necessary to
unscrew the sheet metal screws and pull the wind brace
out. Clean condenser lamellas with help of soft brush or
paint brush. If the condenser is extremely dirty (blocked
lamellas) it is indicated to use vacuum cleaner or com-
pressed nitrogen to suck / blow the dirt from between
lamellas.
The producer shall not be held responsible for damages of the condenser aggregate resulting from non-
observance of condenser cleanliness!
Door seal should be cleaned solely with clean water without any cleansing agents and it sho-
uld be thoroughly dried. The seal cannot get into contact with oily substances or grease!
Control whether door close properly during maintenance procedures.
Test: place a sheet of paper between the seal and the casing and close the door. The paper
should pose a tangible resistance during an attempt to pull it out.
During maintenance services it is necessary to pay attention not to damage the data place of the device
Fig.12 (p.18), which contains signi
fi cant information for servicing organs and waste removal companies.
6. SERVICE
6.1. Fault identi fi cation and repair
In case of any dif fi culties during actuation of the device or during its exploitation, please return to these chapters in this ma-
nual, which explain the performed operation. This aims to ensure that the device is properly operated. If you still experience
dif
fi culties, the following hints will help you solve the problem.
The device is not working... – Make sure that:
• The device is connected to the supply network
• Voltage and frequency in the network are compliant with those recommended by the producer, 230V/50Hz
• The main switch is turned on
• Thermostat is turned on (This concerns the Igloo thermostat – If only two spots are visible on the display – turn on
the thermostat)
The device is operating, but the lighting is off...– Make sure that:
• Lighting switch is turned on
• Fluorescent lamp or starting switch of the device are not burnt
Water leakage from below the device or into the inside of the chamber:
• Check whether the device is properly levelled
• Check the patency of out
fl ow pipes
• Empty the condenser tray or container
• Check whether there is not too much ice in the rail and on the condenser – defrost when necessary
Fig.10 Cleaning the condenser
Elements of device can corrode when improper used and maintenance. To avoid that please
follow the rules:
• Do not allow contact of the surface of the device with substances containing chlorine and / or baking
soda in different varieties, which destroy the protective layer and components of the device (also
includes various stainless steel)
Fig.11 Changing the fl uorescent lamp
1 – Fluorescent lamp handle
2 – Fluorescent lamp
3 – Casing of fl uorescent lamp and
starting switch
4 – Starting switch of fl uorescent lamp
3 4
2 1