en
22
User manual Luzon, Luzon Deep
www.igloo.pl
Do not use water stream to clean the device, only a wet cloth
Do not use any sharp objects to remove dirt!
Devices with wheels cannot be used on uneven surfaces!
During cleaning the inside of the device do not leave the front glass freely lifted in the aluminium profi le.
This may cause the damage of the glass and is not covered by warranty. Please remove the glass with
profi le for the time of cleaning Fig. 11 (p.25).
When using the display cabinet, as well as during maintenance works, pay attention not to destroy the
temperature sensor in the evaporator screen!
Do not use mechanical agents in order to fasten the defrosting process!
The producer shall not be held responsible for damages of the condenser aggregate resul
-
ting from non- observance of condenser cleanliness!
It is recommended to make a break in the exploitation of the device once a month in order to clean its interior,
naturally defrost the evaporator, clean the condenser and verify the condition of door seals.
If the device is not equipped with automatic condensate evaporation, it is essential to remove the condensate from the
container when filling the container Fig.4 (p.5). The number (frequency) of condensate removal depends on device explo
-
itation conditions (f. ex. air humidity, door opening frequency, the amount and temperature of products entered for storage).
I
t is essential to keep the
condenser of the device
clean. Dirt may hinder the heat exchange, causing mainly increase in
electric energy consumption and may cause damage of aggregate compressor.
In order to clean the condenser it is necessary to unscrew the fixing sheet metal screws and pull the wind brace out.
Clean condenser lamellas with help of soft brush or paint brush. If the condenser is extremely dirty (blocked lamellas) it is
indicated to use vacuum cleaner or compressed nitrogen to suck / blow the dirt from be- tween lamellas.
Fig.10 Changing the fluorescent lamp
1– Fluorescent lamp handle
2 – Fluorescent lamp
3 – Casing of fluorescent lamp and starting
switch
4 – Starting switch of fluorescent lamp
Fig.9 Cleaning the condenser
