en
11
User manual DISPLAY COUNTERS NEUTRAL EQUIPMENT
www.igloo.pl
During maintenance it is necessary to take care in order not to damage the name plate which contains
crucial information for servicemen and companies that deal with waste disposal.
Fig. 9. Name plate
5. SERVICE
5.1. Identification of defects and repairs
In case of any difficulties that occur during start-up of the unit and its operation, it is necessary to read those chapters of
the manual that explain the current action. Its purpose is to ensure that the unit is correctly operated. If such difficulties
persist, then the following guidelines shall be followed for the purpose of recovery.
Illumination fails... – Ensure that:
•
Illumination switch has been turned on.
•
Fluorescent lamp has not been burnt.
5.2. Service
IGLOO service landline number is: +48 (14) 662 19 56 or mobile 48 605 606 071
e-mail: [email protected]
If upon control of the content specified in chapter 6.1 „Identification of defects and repairs” the unit still does not work
properly thus it is necessary to contact Igloo Technical Service stating data included in the name plate Fig. 9 (page 5)
.
The foregoing figure shows a model name plate; data included in it are model data non-related to the
display counters.
•
Serial number (NS)
•
Data of manufacture
•
Type (unit name) and data of the unit purchase
•
Trouble description
•
Exact address and telephone number including relevant area code
The name plate is located at the rear of the unit at right upper corner below its top.
IMPORTANT: IN CASE OF FAILURE TO OBEY RULES INCLUDED IN THIS MANUAL AND RELATED TO ACTI
-
VATION AND OPERATION OF THE UNIT, ITS MANUFACTURER RESERVES THE RIGHT TO REFRAIN FROM
RELEVANT OBLIGATIONS OF THE GUARANTOR!!!
Information included in this document can be altered by „IGLOO” without notice. Copying of this manual without the
manufacturer consent is forbidden.
Photographs and figures are specified for information purposes only and these can differ in the unit that has been
purchased.
(Ref. LED LT illumination) During single-side activation of fluore
-
scent lamp it is necessary to check if power lead has been connec
-
ted from appropriate side of this lamp. Power pin point is marked
with an identification label.
Below, a model label is specified. Particular attention shall be paid on
two last entries within the code: type of supply and supply voltage.
