Igloo JAMAJKA 0.6W, Руководство пользователя

Страница: 16 / 44

en
16
User manual Jamajka W, Marta W www.igloo.pl
Fig.6 Control panel
1 – Main switch (turns on/off the aggregate of the
device)
2 – Lighting switch
3 – Thermostat (temperature regulator) panel (servi-
ce details – Chapter No. 7, p. 21 and 22)
4. EXPLOITATION
Temperature of the cooled space and aggregate operating cycle may fl uctuate. They depend on numerous factors,
such as amount and temperature of products placed in the device and temperature of the surroundings.
The device should be placed in a dry and well-ventilated place, ensuring proper air exchange (distance between the
wall and the device – min. 10 cm), out of sunlight, kept far from heat sources and devices enforcing air
fl ow (ceiling
and portable ventilators, blow-in heaters). The device functions properly in a room, where temperature falls within
appropriate climatic class stated on the data plate. The operation of the device may worsen when it shall operate in
temperature lower or higher than the stated temperature range.
Remarks and indications
• The display cabinet has to be properly levelled, which will prevent noisy working of the device and shall
ensure proper water (condensate) out fl ow during defrosting.
• After transporting the device, wait about 2 hours before its actuation.
• The
fi rst fi lling of cooling space should be performed after its previous cooling to working temperature.
This principle should also be observed after longer break in exploitation.
• Do not block any ventilation holes, which would hamper circulation of the cooled air. It is also necessary
to ensure proper air fl ow around the device (aggregate ventilation holes cannot be covered).
• Ensure equal load on the shelves, do not exceed the maximum load.
• Keep the condenser clean. Impurities may lead to overheating of the compressor and as a consequen-
ce may result in damage of the device, which is not covered by warranty.
• Do not use electric devices inside product storing chamber.
• Avoid unnecessary opening of doors and leaving them open for a longer period of time.
4.1. Temperature regulation
The basic aim of a thermostat is to control the cooling aggregate to obtain the set temperature within the device and
maintain it within the determined temperature ranges. The producer enters all settlements of the temperature regulators
required for normal functioning of the device. Before primary actuation the user should control and possibly set the requ-
ired temperature inside the device on the control panel
Digital display – displays the current temperature inside the device
Service of “Igloo” and “Carel” thermostat (temperature regulators) is described in chapter 7 (p.21 and 22)
It is forbidden to interfere with systemic parameters of the thermostat, as this can lead to serious consequ-
ences, including the damage of the cooling device!
1 2 3