![Igloo IWCTLICM353CRHBKS Скачать руководство пользователя страница 11](http://html.mh-extra.com/html/igloo/iwctlicm353crhbks/iwctlicm353crhbks_instructions-and-recipes-manual_622049011.webp)
ENGLISH
9
2.
The ice making cycle lasts 7 to 15 minutes, depending on the ambient room temperature.
3.
While the ice-maker is on, the unit will verify water level periodically. If there is no enough
water to make ice, the ice maker will stop automatically, and the warning indicator will
be on, meaning that the water level can not reach the requirement level for ice making.
4.
The ice maker automatically stops working when the unit has detected full of the ice
inside. At same time the ice-maker indicator will change from blinking to illuminating.
5.
Ensure to keep a reasonable hygiene level in the water tank of the ice
maker. If unit isn’t in use for a long time, take down the water bottle and
drain out all water from both drain port at the back of the unit.
HOW TO GET THE ICE
•
Open the ice getting entrance door and use the ice scoop that is included to scoop the ice.
NOTE
: When you turn on the cold water operation and ice making operation at same
time, wait a few minutes to let the water temperature in the cold tank go down. It
will sthen switch to the ice-making operation. If the cold water temperature goes
up again or you drink the cold water from the cold water faucet, the unit will switch
to Cold Water operation again after the present ice making cycle finished.
REPLACING AN EMPTY BOTTLE
Replace the bottle as soon as you notice that it is empty.
1.
Lift the bottle straight up to disengage it from the bottle probe.
2.
Remove the tamper seal from the bottle cap of the NEW
bottle. DO NOT remove the plastic cap.
3.
Lift the bottle and insert it (assembly directions above). Apply slight pressure
until the plug inside the cap pushes in and the bottle is secure.
HELPFUL TIPS
PROBLEM
CHECK
PROBABLE CAUSE
SOLUTION
Hot and cold water,
ice-maker are all not
available, and the
power indicator
light isn't on
Main power supply
switch in your house
Power plug
Circuit breaker
At "OFF" position
Not plugged in
Tripped
Move to "ON" position
Plug it in
Check and reclose
Hot water anot
available
Hot water button and
hot water indicator
Hot water function
is not turned on
Press the hot water button
on control panel
Содержание IWCTLICM353CRHBKS
Страница 3: ......