8
Timer Off Function
1. The fan can be set to turn off after a certain length of time. To do this, turn
the fan on using the Power (On/Off) button , either on the control panel
or remote. Then press the Timer button . 1h will be displayed on the
control panel and will flash. If the timer is not set, only the wind speed level is
displayed.
2. To change the time using the remote control use the / buttons to
increase/decrease the hour displayed. To set the time leave the hour to flash
5 times on the control panel. This will then set and begin. The timer can be
set from 0-12 hours.
3. To change the time using the control panel, turn the wind speed control dial
to the right to gradually increase the time. When the maximum timer length
is reached (12 hours) a beep will sound to alert you that the time cannot
increase any further. Likewise, when the minimum timer length is reached a
beep will also sound to alert you that the time cannot decrease any further.
To set the time leave the desired hour to flash 5 times on the control panel.
This will then set and begin.
4. Once the timer is set, it will immediately begin counting down until it reaches
0. The fan will then turn off and enter standby mode. Please note the fan will
not beep when it switches off.
5. When both the wind speed and the timer functions have been set, the
control panel will alternatively display each setting with intervals of 10
seconds.
Timer On Function
1. The fan can be sent to turn on after a set period (between 0-12 hours). To
do this ensure that the fan has to be in standby mode (nothing displayed on
the control panel), then press the Timer button . The time will then appear
on the control panel display.
2. You can now change the delay start time shown on the control panel by
turning the wind speed control dial to the right to gradually increase or left
to decrease the time. When the maximum delayed start time is reached
(12 hours) a beep will sound to alert you that the time cannot increase any
further. Likewise, when the minimum delayed start time is reached a beep will
also sound to alert you that the time cannot decrease any further. To set the
time leave the desired hour to flash 5 times on the control panel. This will
then set and begin. Please note that the delay start time length will remain
displayed on the control panel, but the fan will not operate until the time that
has been set elapses.