22
ASP1
Scaling current output with respective configuration
(OU1 = analogue), value at 4 mA
AEP1
Scaling current output with respective configuration
(OU1 = analogue), value at 20 mA
ou2
Switching logic OU2
NO, NC (normally open, normally closed)
dS1
Switch-on delay for OU1 (0���60 s)
dr1
Switch-off delay for OU1 (0���60 s)
dS2
Switch-on delay for OU2 (0���60 s)
dr2
Switch-off delay for OU2 (0���60 s)
Error message
Err1
The value to be displayed is less than -999 or greater than 9999�
►
Check the scaling of the current output (ASP1, AEP1) and set again�
10 Parameter setting via the pushbuttons on the unit
During the parameter setting process the monitoring function of the unit is
maintained� It continues to monitor with the existing parameters until the parameter
setting has been completed�
10.1 Parameter setting in general
3 steps must be taken for each parameter setting:
1
Select parameter
► Press [Mode/Enter] until the reque
-
sted parameter is displayed
.
Mode/Enter Set
