IFM PQ3 Series, Руководство по эксплуатации

Страница: 17 / 19

17
UK
9.4.2 Reset all parameters to factory setting
► Select [rES]�
► Press [Set] and keep it pressed until [----] is displayed�
► Briefly press [Mode/Enter]�
We recommend noting down your own settings before carrying out a reset
(→ 12 Factory setting).
10 Operation
After power on, the unit is in the Run mode (= normal operating mode)� It carries
out its measurement and evaluation functions and provides output signals
according to the set parameters�
Operation indication → chapter 7 Operating and display elements.
10.1 Read set parameters
► Press [Mode/Enter] until the requested parameter is displayed�
► Briefly press [Set]�
> The unit displays the corresponding parameter value for approx� 15 s� After
another 15 s it returns to the Run mode�
10.2 Error indications
[OL] Overload pressure (measuring range exceeded)
[UL] Underload pressure (below measuring range)
[SC1] Short circuit in OUT1*
[C�Loc] Active IO-Link communication, setting buttons locked, parameter change is
rejected�
[S�Loc] Setting buttons locked, parameter change is rejected, unlocking only possible via
IO-Link interface�
[Err] Flashing: internal fault
*The output concerned is switched off as long as the short circuit exists�
The messages SC1 and Err are shown even if the display is switched off�