IFM efector300 SI6000, Руководство по эксплуатации

Страница: 10 / 17

10
6.2 High flow adjustment (optional)
The unit determines the existing flow as normal flow and adapts the display repre-
sentation (all LEDs except the switch point LED light green).
► Let the normal flow circulate in the installation�
► Press the pushbutton and keep it pressed�
> LED 9 lights, after approx. 5 s it flashes.
► Release the pushbutton�
The unit is now adapted to your flow conditions� It passes into the operating mode,
the display should now show example 1�
Note: The adjustment affects the switch point: It is increased proportionally
(maximum up to LED 7).
7 Additional settings (optional)
7.1 Low flow adjustment
If the unit is used in media other than water, you should additionally adapt the unit
to the minimum flow�
Note: The following adjustment must only be carried out after the high flow adjust -
ment�
► Let the minimum flow circulate in the installation or ensure flow standstill�
► Press the pushbutton and keep it pressed�
> LED 0 lights, after approx. 5 s it flashes.
► Release the pushbutton� The unit adopts the new value and passes into the
operating mode�
7.2 Configure the switching output
The unit is delivered as normally open� In case of need you can change the output
to normally closed:
► Press the pushbutton for at least 15 s�
> LED 0 lights, after approx. 5 s it flashes.
> After 10 s the current setting is displayed: LEDs 5...9 light orange (= output
normally open)�
> After approx. 15 s LEDs 0...4 flash orange.
► Release the pushbutton� The output is changed to normally closed operation�
For a new changeover repeat the operation�