Compact speed monitor M18
DI604A
19
u
Set the push ring to [●] to teach SP1 with the current damping frequency and save it.
w
SP1 has been configured.
w
The LED flashes yellow twice for confirmation; then green with a frequency of 1 Hz.
w
The unit is still in the parameter setting mode for the switch point.
If the LED flashes red twice with a frequency of 1 Hz, teaching has failed.
The parameter change has not been saved.
u
Set the push ring to [▼] to change to the parameter setting mode for the start-up delay.
w
The LED flashes green with a frequency of 2 Hz.
w
The unit is in the parameter setting mode for the start-up delay.
u
Set the push ring to [▼] to change to the parameter setting mode for the output function.
OR
Set the push ring to [●] to set the time for the start-up delay.
w
The LED is off.
w
Time set for the start-up delay: 0 s
u
Set the push ring to [●] to save this value.
OR
Each additional pressing of [▼] increases the start-up delay time by 1 s.
w
Each time [▼] is pressed, the LED flashes yellow once. You can set a maximum of 15 s. If you
press [▼] again after this, the LED does not flash and the current value is 0 s. Press [▼] to
increase the time again in steps of 1 s.
u
Set the push ring to [●] to save the set value.
w
The LED flashes yellow twice for confirmation; then green with a frequency of 2 Hz.
w
The unit is still in the parameter setting mode for the start-up delay.
u
Set the push ring to [▼] to change to the parameter setting mode for the output function.
w
The LED quickly flashes green twice per second.
w
The unit is in the parameter setting mode for the output function.
u
Set the push ring to [▼] to terminate the parameter setting of the unit.
OR
Set the push ring to [●] to set the output function.
w
The LED lights yellow.
w
The output function [Normally open] is set.
u
Set the push ring to [●] to save this value.
OR
Set the push ring to [▼] to set the output function [Normally closed].
w
The LED is off.
w
The output function [Normally closed] is set.
Press [▼] again to change between [Normally open] (LED lights yellow) and [Normally closed]
(LED off).
u
Set the push ring to [●] to save the set value.
w
The LED flashes yellow twice for confirmation; then it quickly flashes green twice per second.
w
The unit is still in the parameter setting mode for the output function.
u
Set the push ring to [▼] to terminate the parameter setting of the unit.
w
The unit changes to the operating mode.
