IFB Senorita Dx, Руководство пользователя

Страница: 17 / 27

CHECK POINTS:
Before switching your machine ‘ON’ check if …..
The power supply plug is connected to a 230 V, 50 Hz supply with good earthing.
The water inlet stopcock is fully open.
The inlet and exhaust hoses are straight and free from twist.
The coin trap is closed firmly and exhaust pipe is connected to drain.
PROGRAMMING THE MACHINE:
1. Switch ON the mains supply.
2. Rotate the programmer knob to the desired program.
3. Select the options preferred for the chosen program from the flashing options. After selection, the Led of
the chosen options will glow.
The chosen options can be deselected by pressing the button again.
Non-flashing options indicate that they are not applicable for the corresponding program.
4. Open the door and load the clothes inside the drum.
5. Put the detergent in the respective chamber.
6. Press the “Start/Pause” button to start the washing cycle. Flashing of optional button Led will turn OFF.
Door led will flash green &will glow red once the door is locked. status Led’s will glow depending on the phase of
the program.
7. If required enable the ‘Child lock’ feature to prevent any tampering of program.
8. To change the options, Pause the machine è Select / Deselect the options è Press Start button. The machine will
acknowledge the changes done automatically.
9. To change / cancel the program during the machine run,
Press Pause button
è
Switch OFF the machine
è
Switch
ON è Select a new program
10. Washing, Soaking, Rinsing & Spinning can be seen through the porthole door.
MACHINE STATUS INDICATION:
Door led will glow/Flash indicating the status of the door
During error mode the error codes will be indicated
WHEN THE PROGRAM HAS ENDED:
At the end of the program “End” LED will glow.
Door LED will at the end of the program.
Start/Pause LED will at the end of the Program
Open the door by pulling the door handle to remove the clothes from the machine
Switch OFF the machine by rotating the program selector knob to “OFF” position.
Leave door slightly ajar between washes to dry out the inside of the machine, to preserve the door seal.
l
l
l
l
l
l
l
l
Glow Green
l
switch off
l
only after the door LED
glows green.
l
l
.
19