iET PRS-300 Series, Руководство по эксплуатации, Страница: 48 / 50

PRS-300 Series
APPENDIX B 38
SYSTem:LOCal: This command places device in the LOCAL mode and unlocks all keys
on front panel of the device. The Command is valid only for RS232, and USB interfaces.
SYSTem:REMote This command places device in the REMOTE mode and locks all
keys. The Command is valid only for RS232, and USB interfaces.
CALIBRATION Commands
CALIbrate:RESistance Goes into calibration mode starting at resistor 1 and then progressing
to resistor 43. Each time the command CALI:RES:SET is used the resistor number is automatically
incremented by 1.
CALIbrate:RESistance? Returns resistance number to be calibrated.
Numbers 1 to 43
CALIbrate:RESistance:SET <number> Sets calibrated value of resistance in ohms into mem-
ory. <number> is a fl oating point number representing the resistance value in ohms for the internal
resistor being measured. Each time the command CALI:RES:SET is used the resistor number is
automatically incremented by 1.
CALIbrate:RESistance:SET? Returns the calibrated value of resistance in ohms
CALIbrate:DATE <mmddyyyy> Sets calibration date into memory
CALIbrate:DATE? Returns calibration date in format mmddyyyy
SOURCE Commands
SOURce:DATA <display value> Sets output resistance of the PRS-300 if table is set to 0
or the resistance value corresponding to the display value for the table selected.
Display value in form of number and decimal point representing desired display value.
example SOURce:DATA 1.000002 would set resistance value to 1.000002 Ω if Table is set to
0.
SOURce:DATA? Returns display value currently shown in the PRS display