Ier steamOvap, Инструкция по установке и эксплуатации

Страница: 32 / 48

I N S T A L L A T I O N
Verification before start-up
Warning
For safety and warranty reasons, Installa on and service of this humidifier should be carried out
by trained and qualified personnel.
Any work related to installa on and service of this humidifier must comply with local code and
regula on regarding safety and preven on of accidents.
Risk of electric shock .
Disconnect power supply before verifica on.
Risk of malfunc on. Steam lines should not have any restric on or blockage that may
cause a burst of pressure in the steam line.
Risk of flooding. In order to avoid any risk of flooding steamOvap recommends a Hi limit
humidity switch installa on in the air duct downstream of the steam distribu on ramp.
Risk of freezing . Plan an an -freeze system in case of installa on in a loca on that
would be exposed to outside condi ons and suscep ble of freezing.
Risk of malfunc on. Do not block steam outlet(s).
Check list

Moun ng
o
Check moun ng to verify that the IER is level and securely supported before filling
with water.

Water supply
o
Verify that all piping connec ons have been completed as recommended and that
water pressure is available.
o
Once water shut off valve is open, verify for any possible leaks.

Drain
o
Verify that all drain piping has been completed as recommended and that an open
drain deported from
IER is provided.

Steam
o
Verify that all steam piping has been completed as recommended and that a slope
of minimum 2° is provided.
o
Ensure that there is no sag or kink or any possible obstruc on in the steam line, and
condensate line.

Power supply
o
Verify that power supply wires have been connected to main terminal and ensure
that all wires are safely ghtened. Ensure that an all pole disconnec ng device with
fuses is installed and easily accessible.

Control circuit
o
Verify that safety controls such as air proving switch and Hi limit humidistat have
been connected.
o
Verify that a control signal demand or RH% sensor is connected to the control
terminals.
Once all above verifica on has been completed and found sa sfactory you can powered up the
IER steam Humidifier.
32
