Iembeddedpc PEB-7605 Series, Руководство пользователя

Страница: 28 / 37

PEB-7605 Series User’s Manual
27
Onboard FDC Controller
Select “ Enabled ” if your system has a floppy disk controller (FDC) installed on the system board and you wish to use it. If you
install an add-in FDC or the system has no floppy drive, select “ Disabled ”. Options: Enabled (default)
、
Disabled
Onboard Serial Port 1
Select an address and corresponding interrupt for the first/ second serial port.Options: Disabled
、
3F8/IRQ4 (default for port1)
、
2F8/IRQ3
、
3E8/IRQ4
、
2E8/IRQ3
、
Auto
Onboard Serial Port 2
Select an address and corresponding interrupt for the first/ second serial port.Options: Disabled
、
3F8/IRQ4 (default for port1)
、
2F8/IRQ3
、
3E8/IRQ4
、
2E8/IRQ3
、
Auto
Onboard Serial Port 3
Select an address and corresponding interrupt for the first/ second serial port.Options: Disabled
、
3E8 (default for port1)
、
2F8
、
3F8
、
2E8
Serial Port 3 Use IRQ
Select an address and corresponding interrupt for the first/ second serial port.Options: Disabled
、
IRQ10 (default for port1)
、
IRQ11
、
IRQ3
、
IRQ4
Onboard Serial Port 4
Select an address and corresponding interrupt for the first/ second serial port.Options: Disabled
、
2E8 (default for port1)
、
2F8
、
3F8
、
3E8
Serial Port 4 Use IRQ
Select an address and corresponding interrupt for the first/ second serial port.Options: Disabled
、
IRQ11 (default for port1)
、
IRQ10
、
IRQ3
、
IRQ4
Onboard Parallel Port
Select an address and corresponding interrupt for the onboard parallel port.Options: 378/IRQ7 (default)
、
278/IRQ5
、
3BC/IRQ7
、
Disabled
Parallel Port Mode
This option allows you to select a parallel port mode for the onboard parallel port.
Options:
ECP (default) Extended Capabilities Port.
EPP Enhanced Parallel Port.
SPP Standard Printer Port.
ECP+EPP ECP & EPP mode.
Normal
EPP Mode Select
Select EPP port type 1.7 or 1.9. This field is only configurable if “Parallel Port Mode” is set to “EPP” or “ECP+EPP”. Options:
EPP 1.9(default)
、
EPP 1.7
ECP Mode Use DMA
Select a DMA Channel for the parallel port when using the ECP mode. This field is only configurable if “Parallel Port Mode” is
set to “ECP”. Options: 3 (default)
、
1
Power On After Power Fail
This item is to set whether to run AC loss Auto Re-star or OFF