IEM Libr-O-Graph Med, Руководство по эксплуатации

Страница: 30 / 130

2. Stand on the middle of the scales. Remain still
and do not hold on to anything until the weight
displayed stops at a constant value.
ð
The scales will confirm this with 1 short
bleep . The display ‘bt’ signals that the data
transfer has begun.
3. You can now get off the scales.
4. Wait until the data has been successfully trans-
ferred, which is signalled with
1 short bleep
and ‘0000’ on the display.
If the data transfer does not work, then the scales
signal this with
12 short bleeps . An error number
is also shown on the display. Read
Ä
Chapter 10
‘Error messages of the scales’ on page 33 , to find
the cause of the error and how to correct it. After
you have corrected the error, repeat the weighing
process.
If the measurement value is not transferred immedi-
ately following the measurement, it is saved in the
internal memory of the scales (max. 20 measure-
ment values). All values which have been saved but
which have not yet been transferred are then trans-
ferred next time.
i
If there are more than twenty measurements in
the memory, the oldest values are overwritten.
8 Battery change
A battery change is necessary if ‘bAtt’ is shown in
the display or if the batteries are defective.
8 Battery change
GB
30