IEI Technology POS-6614, Руководство пользователя

Страница: 33 / 236

POS-6614 Motherboard
General
o
Meet LPC Spec. 1.01
o
Support LDRQ#(LPC DMA), SERIRQ (serial IRQ)
o
Include all the features of Winbond I/O W83877TF
o
Integrate Hardware Monitor functions
o
Compliant with Microsoft PC98/PC99 Hardware Design Guide
o
Support DPM (Device Power Management), ACPI
o
Programmable configuration settings
FDC
o
Compatible with IBM PC AT disk drive systems
o
Variable write pre-compensation with track selectable capability
o
Support vertical recording format
o
DMA enable logic
o
16-byte data FIFOs
o
Support floppy disk drives and tape drives
o
Detects all overrun and under run conditions
o
Built-in address mark detection circuit to simplify the read electronics
o
FDD anti-virus functions with software write protect and FDD write enable
signal (write data signal was forced to be inactive)
o
Completely compatible with industry standard 82077
o
360K/720K/1.2M/1.44M/2.88M format; 250K, 300K, 500K, 1M, 2M bps
data transfer rate
o
Support 3-mode FDD, and its Win95/98 driver
UART
o
Two high-speed 16550 compatible UARTs with 16-byte send/receive
FIFOs
o
MIDI compatible
o
Fully programmable serial-interface characteristics:
•
5, 6, 7 or 8-bit characters
•
Even, odd or no parity bit generation/detection
•
1, 1.5 or 2 stop bits generation
o
Internal diagnostic capabilities:
•
Loop-back controls for communications link fault isolation
•
Break, parity, overrun, framing error simulation
o
Programmable baud generator allows division of 1.8461 MHz and 24
MHz by 1 to (216-1)
Page 33