PAC-1000G QIG IEI Technology Corp. Page 4
STEP 3: INSTALL THE POWER SUPPLY UNIT (PSU)
Once the top cover and hold-down clamp have been removed, the PSU must be installed. Compatible IEI PSUs are listed in the table below.
Output Range
Model No.
Input
Type
Watt
+3.3V
+5V
+12V1
+12V2
-5V
-12V
+5Vsb
ACE-832AP-RS
AC ATX
300W
28A 30A 15A N/A 0.3A 0.8A 2A
ACE-841AP-S-RS
AC ATX
400W
28A 33A 20A N/A 0.5A 1A 2A
ACE-850AP-RS
AC ATX
500W
27A 29A 18A 18A 0.3A 0.8A 2A
Table 2: Compatible IEI PSUs.
The PSU is installed at the rear of the chassis and secured to the
chassis with six retention screws, four retention screws at the
rear of the chassis and two on the right side of the chassis. To
install the PSU, please follow the steps below.
Step 1:
Slide the two clip nuts onto the two clips on the
cable side of the PSU.
Figure 6: Slide Two Clip nuts onto the Two Clips of PSU
Step 2:
Correctly position the PSU at the rear of the
chassis. Make sure the power switch and the
cable socket both face outwards.
Step 3:
Secure the PSU to the rear of the chassis. To do
this, insert four retention screws from the rear of
the chassis and two retention screws from the
right side of the chassis.
Step 0:
Figure 7: Six PSU Retention Screws
STEP 4: Backplane Installation
The IEI backplanes listed below are compatible with the
PAC-1000G chassis.
Model No.
SBC Type
PCI
ISA
PSU
BP-6S-RS-R30 ISA
0
6 AT
IP-6S-RS-R30 PCISA
3
2 AT
IP-6SA-RS-R30 PCISA
3
2 ATX
PCI-6S-RS-R30 PICMG
1.0 4
2 ATX/AT
Tabel 1: Compatible Backplane Modules
To install a backplane, please follow the instructions below:
Step 1:
Insert six copper pillars into the six predrilled elevated
screw holes in the base of the chassis.
Figure 8: Six Copper Pillars
Step 2:
Mount the backplane onto the copper pillars and the
three predrilled elevated retention screw holes. Make
sure the backplane screw holes are aligned with the
screw holes in the copper pillar and the predrilled
retention screw holes.
