IEI Technology KINO-G45A, Руководство пользователя

Страница: 54 / 128

KINO-G45A Mini-ITX Motherboard
Page 43
4.3 Jumper Settings
NOTE:
A jumper is a metal bridge used to close
an electrical circuit. It consists of two or
three metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
The hardware jumpers must be set before installation. Jumpers are shown in Table 4-1 .
Description Label Type
AT/ATX Auto power setting
jumper
JAUTO1 2-pin header
Clear CMOS jumper J_CMOS1 3-pin header
Table 4-1: Jumpers
4.3.1 AT/ATX Power Mode
Jumper Label: JAUTO1
Jumper Type:
2-pin header
Jumper Settings:
See Table 4-2
Jumper Location: See Figure 4-8
The AT Power Select jumper specifies the systems power mode as AT or ATX.