IEI Technology IMBA-Q454-R10, Руководство пользователя

Страница: 72 / 213

IMBA-Q454-R10 User Manual
Page 72
4.4 Jumper Settings
NOTE:
A jumper is a metal bridge that is
used to close an electrical circuit. It
consists of two metal pins and a small
metal clip (often protected by a plastic
cover) that slides over the pins to
connect them. To CLOSE/SHORT a
jumper means connecting the pins of
the jumper with the plastic clip and to
OPEN a jumper means removing the plastic clip from a jumper.
Before the IMBA-Q454-R10 is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the IMBA-Q454-R10 are listed
in
8
Table 4-1 .
Description Label Type
Clear CMOS J_CMOS1 3-pin header
iTPM setup jumpers JTPM1
JTPM2
2-pin header
Table 4-1: Jumpers
4.4.1 Clear CMOS Jumper
Jumper Label: J_CMOS1
Jumper Type: 3-pin header
Jumper Settings:
See
8
Table 4-2
Jumper Location:
See
8
Figure 4-8
If the IMBA-Q454-R10 fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
Jumper