IEI Technology eNOVA-945GSE, Руководство пользователя

Страница: 83 / 211

eNOVA-945GSE Motherboard
Page 67
Step 2: Align the SO-DIMM with the socket . The SO-DIMM must be oriented in such a
way that the notch in the middle of the SO-DIMM must be aligned with the
plastic bridge in the socket.
Step 3: Insert the SO-DIMM . Push the SO-DIMM chip into the socket at an angle. (See
Figure 5-1 )
Step 4: Open the SO-DIMM socket arms . Gently pull the arms of the SO-DIMM socket
out and push the rear of the SO-DIMM down. (See Figure 5-1 )
Step 5: Secure the SO-DIMM . Release the arms on the SO-DIMM socket. They clip into
place and secure the SO-DIMM in the socket. Step 0:
5.5 CF Card Installation
NOTE:
The eNOVA-945GSE can support both CF Type I cards and CF Type II
cards. For the complete specifications of the supported CF cards
please refer to Chapter 2.
To install the a CF card (Type 1 or Type 2) onto the eNOVA-945GSE, please follow the
steps below:
Step 1: Locate the CF card socket . Place the eNOVA-945GSE on an anti-static pad
with the solder side facing up. Locate the CF card.
Step 2: Align the CF card . Make sure the CF card is properly aligned with the CF
socket.
Step 3: Insert the CF card . Gently insert the CF card into the socket making sure the
socket pins are properly inserted into the socket. See Figure 5-2 . Step 3: