IEI Technology AFL2-17AB-H61 Series, Руководство пользователя

Страница: 45 / 178

AFL2-17AB-H61
P a g e 29
S te p 6: Secure the HDD to the bracket using four (4) retention screws (two screws on
each side) ( Figure 4-5 ).
Figure 4-5: Securing the HDD
S te p 7:
Slide the HDD module back into the device.
S te p 8: Tighten the captive screw.
S te p 9: Replace the HDD cover and secure it using two (2) retention screws. S te p 0:
4.5 K-Typ e Te m p e ra tu re S e n s o r In s ta lla tio n
The AFL2-17AB-H61 has a K-type connector on the external peripheral interface panel.
The K-type connector is connected to a K-type temperature sensor cable. The K-type
temperature sensor cable can be found in the packing list. To connect a K-type
temperature sensor cable to the AFL2-17AB-H61, please follow the instructions below.
S te p 1:
Locate the K-type connector . The location is shown in Chapter 1 .
S te p 2: Align the connector. Align the K-type temperature sensor cable with the K-type
connector on the AFL2-17AB-H61 . Make sure the orientation of the connector is
correct.