IDTECK Star 100R, Руководство пользователя

Страница: 27 / 40

27
15. Troubleshooting
If a problem occurs during the use of this product, do not attempt to disassemble the product by
yourself.
Please check the following suggestions. If your problem still persists, contact our customer
service center.
[Operation]
● Problem
When power is first supplied, 3 LEDs of 100R blinks only and an RF card doesn’t recognize.
● Cause
▶
System initialization Status (Unregistered Master Card (or PIN))
▶
System malfunction/data damaged or lost due to an external noise or a short circuit.
▶
Internal circuit element damaged or malfunctioning
● Solution
▶
Make sure that installation and operation are normal.
☞
When installing the 100R first or When finishing system initialization.
Because system is the status of initialization, register mode selection, master card
(or PIN) and user.
1. 100R Mode Selection: Mode ENT
RF Only 01 + ENT
RF + P/W 02 + ENT
PIN Only 03 + ENT
RF or PIN 05 + ENT
2. Enter the master card (or PIN: 4 to 6digit (mode 03 or 05) + ENT).
3. By modes, enter the master card, PIN and password.
4. Enter the master card (or PIN: 4 to 6digit (mode 03 or 05) + ENT).
☞
When problem occurs while 100R operates normally.
It is caused by system malfunctions.
1. Turn on the 100R when it’s off. (OFF Î ON).
•
If this does not solve the problem, initialize the product
#1)
.
● If the problem still persists, contact our customer service center.
#1)
System Initialization: See page 24 of this manual.
#2)
Initial Setting: See page 10 of this manual.
See “Initial Setting
#2)
” to register master or user.
Caution
Upon initialization, all data default value will be restored. Caution