REVISION 12/03/15
2
VERSACLOCK
®
6 - 5P49V69xx Family Programmer Board
Figure 2. Programmer Board Overview (socket open)
Programming Steps
1.
Place a blank part in the socket
–Refer to
Figure 2
above. With socket opened, identify pin 1 position and place a blank part
accordingly. Close the socket and secure the socket lid.
2.
Plug the board into USB port
–USB port provides power to the board as well as a communication channel between GUI and
the device.
3.
Start Timing Commander GUI
–Launch the Timing Commander GUI software. Load the proper personality file.
4.
Start a new settings file
or open a pre-optimized configuration file.
5.
Connect to the board
–Click on the chip symbol on the top-right corner of the GUI window, as shown in
Figure 3
below (left).
A rectangular area in green will display (right).
Figure 3. Connecting to the chip: Left: click on the chip symbol to make the connection; Right: A green area
appears if I
2
C communication is established.
6.
Execute “Write All” command
–Double check the setting file that is open in GUI window and make sure everything is correct.
Then click on “Write-All” symbol in the green area (See
Figure 3
above, right). This is a step that must be executed before OTP
programming of the device.
7.
Click on OTP button in the GUI
–On lower left portion of GUI window, there is a button called OTP (
Figure 4
: left). Click this
button to open OTP Programming dialogue window (
Figure 4
: right).
Pin 1
