54
where you define position, and “from Out” is to move a card from the card out sensor to
where you define position.
Rotate
Rotator is to flip over a card in the printer installed flipper. “Auto” is to move a card from
printer to flipper and flip over a card and move a card to the printing position automatically.
“Batch” is to repeat “Auto” as many times as the number of set. “To Bottom” is to turn to
the backside of card and “To Top” is to turn to the front side of card.
Etc
“Cleaning Roller” is to clean the roller by cleaning card automatically. “Use Log” is to
display log in message space.
(3) Print
Print can be done through the CSD file which is designed by Smart Design program. Following the
steps in this section.
1.
Click
“…”
button and select the CSD file.
2.
Click
“Open”
button to prepare CSD file to print.
3.
Click
“Print”
Button
to m
ove print data to spool. In the NORMAL mode, Click “Print” button
to print a card, but in the SBS mode, “Print” button to transmit a printing data from PC to
printer and wait for printing. Therefore, you must click “DoPrint” to print in SBS mode. This
function is for detail control of printer.
4.
Click
“Close”
button to close CSD file.
(4) Batch
Batch is to repeat encoding/decoding test continuously. In the Repeat, you input the number of
repeat and click “Batch Start”, then the test is run as many times as the number of set. When you
check
“Include Card In/Out”
, each time the printer bring a card from input hopper and perform an
encoding test and eject the card. But if not, encoding test will be done only by one card. At that time,
if there is no card in the printer, the printer bring a card into the printer from input hopper and repeat
the encoding test on the card, and if there is a card in the printer, the encoding test is performed on
the card repeatedly.
“Card Holding”
is activated when “Include Card In/Out” is ticked. When “Card
Holding” is ticked and the repeat number is set, the printer repeats the encoding test as many times
as the number of set in the “Card Holding” without ejection. When it is completed, the printer ejects
the card and brings a new card into the printer and starts testing.
