Electronic Pushbutton Locks
EL730SLR
© 2017 IDN, Inc. All rights reserved.
0817
39
A
A
A
A
A
A
A
A
SET
DEL
1
2
3
4
5
6
7
8
9
0
C
SETUP MODE
HOW TO SETUP AUTO-LOCK TIME DELAY
Steps are as follows:
1. Press and hold [SET] button for over 2 seconds.
The Red LED will light up and beep twice. You are now under setup mode.
2. Enter 123456 (or current programming code) and then press button .
Enter [70] and press button .
Enter the seconds for delay time of auto-locking (10 to 90) and press button .
The Red LED will light up for 10 seconds. The lockset will setup auto-lock time delay.
Note:
1.The lockset will go back to the standby status if no button is
pressed in 10 seconds after accessing setup mode.
2.The lockset will flash and beep three times if the seconds for
delay time of auto-locking is not within 10 to 90 seconds.
3.Default auto-lock time delay is 10 seconds.
A
A
A
A
A
A
A
A
SET
DEL
1
2
3
4
5
6
7
8
9
0
C
40
SETUP MODE
HOW TO ENABLE DOUBLE AUTHORIZATION MODE
(only available for Proximity Card Electronic Deadbolt/ Remote Control Electronic Deadbolt)
Steps are as follows:
1. Press and hold [SET] button for over 2 seconds. The Red LED will light up and beep twice.
You are now under setup mode.
2. Enter 123456 (or current programming code) and then press button .
Enter [99] and press button .
3. Enter [0] and press button .
The Red LED will light up for 10 seconds. The lockset will turn on double authorization mode.
(When the double authorization mode is turned on, both user code and card, or both user code and remote
control, must be authenticated to unlock the lockset)
4. Enter [1] and press button .
The Red LED will light up for 10 seconds. The lockset will turn
off double authorization mode. (default double authorization
mode is off)
Note:
1.The lockset will go back to the standby status if no button is
pressed in 10 seconds after accessing setup mode.
2.Please make sure that both user code and card, or both user
code and remote control, are stored in the lockset before you
turn on double authorization mode.
