Idmed ToFscan, Руководство по обслуживанию

Страница: 16 / 28

Service Manual ToFscan - Rev G 16
Replacing the battery on ToFscan before 2020
To replace the battery, go through all the steps of the dismantling procedure.
It is necessary to replace the cable tie by a new one.
Furthermore, in order to secure the battery:
- Remove the used foam pieces from the motherboard.
- Reposition the new ones. Be sure to use the new double-sided adhesive cushioning foams to
position the battery on the motherboard.
- Insert the new zip tie making sure to leave the same length on each side of the battery. The zip tie
must be at least 12cm (4.5inches) long.
- Roll on itself the battery cable, then position back the battery on the motherboard Ensure the
battery sticks out by 5mm (1/4 inch) from the PCB card. (See picture below).
- Tighten the zip tie then cut the excess part. Do not over-tighten the zip tie to avoid breakage.
- Check that the battery is immobilized
- Put some hot glue on the battery connector to avoid it from moving.
Finally, reassemble ToFscan, see chapter ToFscan reassembly
After any servicing on ToFscan or its accessories, always validate its performance using the
TOF-Controller.
Please keep the battery date in your traceability documents.
Replacing the battery on ToFscan from 2020
To replace the battery, go through step 1 to 3 of the dismantling procedure.
To make sure the battery is securely in place, do not over screw the battery holder as it may brake.
Finally, reassemble ToFscan, see chapter ToFscan reassembly.
After any servicing on ToFscan or its accessories, always validate its performance using the
TOF-Controller.
Please keep the battery date in your traceability documents.
Replacing the mother board
To replace the mother board, go through all the steps of the dismantling procedure.
Then:
For ToFscan prior 2020, install the battery directly on motherboard. See chapter battery replacement.
Finally, reassemble ToFscan, see chapter ToFscan reassembly.
After any servicing on ToFscan or its accessories, always validate its performance using the
TOF-Controller.
Please keep the motherboard “LOT” number in your traceability documents.