NJR-TW01UHD/NJR-RW01UHD User Guide
39
9.2 Setting output
9.2.1 Output mode
You can set the color space to be sent to the sink device.
The sink device selects the best color space for the color space of the input video automatically, but if for
some reason the sink device cannot select the color space, set the desired color space in NJR-TW01UHD or
NJR-RW01UHD.
For NJR-TW01UHD, output mode can individually be set to the output from the HDMI OUTPUT connector
(local output) and output connector for extension.
Setting value
AUTO [Default]
DVI output
RGB output
YCbCr 4:2:2 output
YCbCr 4:4:4 output
YCbCr 4:2:0 output
Note:
This setting is enabled when HDMI signal is input.
Communication command
@SDM Setting output mode
@GDM Getting output mode
9.2.2 HDCP output
You can set the HDCP output for when a HDCP-compliant device is connected.
Normally select “ALWAYS” to output HDCP at all times regardless of input signal status.
If you select “HDCP INPUT ONLY”, HDCP will be output only if the input signal has HDCP. However, some
sink devices fails HDCP authentication when HDCP is switched from OFF to ON; this results in that video and
audio may not be output temporarily.
Setting value
ALWAYS [Default]
HDCP INPUT ONLY
HDCP 2.2
Communication command
@SEN Setting HDCP output
@GEN Getting HDCP output
NJR-RW01UHD
NJR-TW01UHD/NJR-RW01UHD
