30
Installation, Support, and Maintenance Guide
iQ 200 Rackmount Satellite Router
Coax Cable Preparation
•
Co-channel interference causes degradation and higher packet loss rate
•
Good return loss
– High quality cable and correct connectors help ensure an optimal
return loss of 10 dB or more
To terminate the cables with F-Type connectors:
1.
Cut off each end of the coax cable squarely, using the proper cable cutter as shown in
Figure
C-1. Coax Cable Cutting Technique
2.
Remove the jacket material and foam insulation according to the length defined under
Length A
in
. For RG-6, use a two-step Coax Stripper such as the LC-CST 1257
from Paladin Tools.
NOTE:
Excessive DC Resistance – will result in excessive voltage drop across the
IFL cable. Hence, the voltage at the BUC may be too low to operate properly.
NOTE:
lists all of the recommended tools
for terminating coax cables.
WARNING:
Wear protective eye wear while cutting cables and terminating
connectors.
WARNING:
The center conductor must be straight and cylindrical without any
burrs. Failure to do so can damage the satellite router, BUC, and/or LNB input
connector.
Table
C-1. Coax Trim Dimensions
Length A
(inch (mm))
Length B
(inch (mm))
Length C
(inch (mm))
RG-6
5/8 (15.9)
1/4 (6.4)
3/8 (9.5)
Содержание iQ 200
