iDiPOS TP-80, Руководство пользователя, Страница: 48 / 54

47
[Format] ASCII FS S n 1 n2
Hex 1C 53 n 1 n2
Decimal 28 83 n 1 n2
[Range] 0 ≤ n 1 ≤ 255
0
≤
n 2
≤
255
[Description] Sets left- and right-side Kanji character spacing n1 and n2 , respectively.
•
When the printer model used supports GS P , the left-side character spacing is
[ n1 ╳ horizontal or vertical motion units], and the right-side character spacing is
[ n2 ╳ horizontal or vertical motion units].
[Details]
•
When double-width mode is set, the left- and right-side character spacing is
twice as the normal value.
•
The horizontal and vertical motion units are set by GS P . The previously
specified character spacing does not change, even if the horizontal or vertical
motion unit is changed using
GS P .
•
In standard mode, the horizontal motion unit is used.
•
In page mode, the horizontal or vertical motion unit differs in page mode,
depending on starting position of the printable area as follows:
①
When the starting position is set to the upper left or lower right of the
printable area using ESC T , the horizontal motion unit ( x) is used.
②
When the starting position is set to the upper right or lower left of the
printable area using ESC T , the vertical motion unit ( y) is used.
③
The maximum right-side spacing is 255/180 inches for the paper roll and is
approximately 36mm. Any setting exceeding the maximum is converted to the
maximum automatically.
[Default] n1 = 0, n2 = 0
[Reference] GS P
70. FS W n
[Name] Turn quadruple-size mode on/off for Kanji characters
[Format] ASCII FS W n
Hex 1C 57 n
Decimal 28 87 n
[Range] 0 ≤ n ≤ 255
[Description] Turns quadruple-size mode on or off for Kanji characters.
•
When the LSB of n is 0, quadruple-size mode for Kanji characters is turned off.
•
When the LSB of n is 1, quadruple-size mode for Kanji characters is turned on.
[Details]
•
Only the lowest bit of n is valid.
•
In quadruple-size mode, the printer prints with same size characters as when
double-width and double-height modes are both turned on.
•
When quadruple-size mode is turned off using this command, the following
characters are printed in normal size.
•
When some of the characters on a line are different in height, all the characters
on the line are aligned at the baseline.
•
FS ! or GS ! can also select and cancel quadruple-size mode by selecting
double-height and double-width modes, and the setting of the last received
command is effective.
[Default] n = 0
[Reference] FS ! , GS !
Beeping commands