Operator Manual
Aspect 100RT
L100-3061 REV A
21
BATTERY FUNCTION (MOTORIZED TABLES)
When AC power is applied, the battery will begin charging until the battery reaches full
capacity. When it does, the charging will taper off. If the power goes out, the table will
automatically switch to battery back-up mode.
Note: The battery will not charge if the emergency stop switch is pushed down.
An audible tone is sounded when using an operator control function if the battery
charge is low.
Local procedures may be in place for proper disposal or recycling.
For more information about batteries, such as battery life, production
codes and
disposal go to the Linak web site for disposal information.
Select “Products|User Manuals” and click on “Actuators & Electronics”.
Linak documentation can be found at their web site:
GENERAL CLEANING
The disinfectant cleaners and cleaning steps on this page apply to all the parts of the table, except the
radiation shield.
• Clean tabletop, pads, accessories, and painted surfaces with a clean cloth dampened
with an approved cleaner (see list below).
Do not use abrasives, solvents, sprays, or corrosive agents.
APPROVED AND TESTED DISINFECTANT CLEANERS
•
Sodium hypochlorite (generic household bleach) in solution of 5.25% sodium hypochlorite
diluted between 1:10 and 1:100 with water.
•
Alcohol (generic)
•
Envirocide ®
Disinfectant and Cleaner
CAUTION
After each procedure, the table should be carefully
cleaned.
