Installation
X- Smart Pro
V 2.0
19
Remove the plastic protection on the canisters
1. Open the front door.
2. Remove the foam.
3. Close the front door.
4. Remove the brush foam.
4.2
Put the machine in position
4.2.1
Move the machine to the final position
Warning
Mind the minimum requirements of the load capacity of the floor. See
page 20.
Note
Make sure that the final location is well-lit and well-ventilated.
To place in position:
1. Move the machine backwards from the pallet on to the
ground. Optionally use a ramp (A).
2. Move the machine to the final location.
