![background image](http://html1.mh-extra.com/html/idex/band-it-s10099/band-it-s10099_manaul_3725469017.webp)
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Document # P09287 rev. L
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved
www.BAND-IT-IDEX.com
Page 17 of 18
S10099
Classic Air Tool
Filter/Lubricator
INSTRUCTIONS
1. REMOVE ¼” NPT PLUG FROM AIR SUPPLY “IN” PORT.
2. ASSEMBLE 90° ELBOW MALE END INTO FEMALE END OF AIR SUPPLY “IN” PORT. BE SURE FEMALE END
OF 90° ELBOW IS IN DIRECTION SHOWN AFTER ASSEMBLY.
3. USE OPEN FACE WRENCH ON 90° ELBOW TO ASSEMBLE MALE END OF LONG NIPPLE SUB-ASSEMBLY
INTO ASSEMBLED 90° ELBOW FEMALE PORT. BE SURE MALE END OF 90° ELBOW IS FACING STRAIGHT
BACK IN CENTER LINE OF PULL-UP CYLINDER AS SHOWN.
4. ASSEMBLE SWIVEL FITTING OF FILTER / LUBRICATOR SUB-ASSEMBLY SHOWN TO MALE END OF
ASSEMBLED 90° ELBOW. BE SURE THAT FILTER AND LUBRICATOR ARE STRAIGHT UP AND DOWN.
NOTE:
FILTER AND LUBRICATOR SUB-ASSEMBLY MAY BE ASSEMBLED AWAY FROM TOOL, NO MORE THAN 30”
FROM AIR SUPPLY “IN” PORT. FILTER AND LUBRICATOR MUST BE IN DIRECT LINE WITH TOOL, NO OTHER
HOOKUPS ALLOWED BETWEEN FILTER / LUBRICATOR AND TOOL.
PRIOR TO HOOKING UP AIR SUPPLY TO TOOL, UNSCREW THE TWO FILLER PORT SCREWS ON OPPOSITE
SIDE OF EACH OTHER AND FILL BOWL HALF WAY WITH DTE 24 HYDRAULIC OIL PROVIDED WITH KIT.
ADJUST DRIP RATE TO ONE DROP FOR EVERY 6 TO 7 CYCLES.
TO DRAIN AIR FILTER, TURN KNURLED KNOB COUNTERCLOCKWISE (IN).
USE OF THE S10099 AIR TOOL WITHOUT A FILTER / LUBRICATOR VOIDS THE WARRANTY.
LUBRICATOR
SWIVEL FITTING
¼” NPT PLUG
90° ELBOW
AIR FILTER
HEX NIPPLE
FILLER PORT
LONG NIPPLE
90° ELBOW
AIR SUPPLY “IN” PORT