IDEAL MSC-18K-B, Руководство пользователя

Страница: 20 / 43

19
Mar 2016
MSC-18K
4. LIFTING OPERATION
The assembled lifting system must be checked for correct working and
adjustments and a complete operational test should be carried out by using a
typical vehicle.
Remarks:
-When using this lifting system, leave a space for a 24” (600mm) wide passage
around the lifting system, which can serve as escape route.
-Before using the Mobile Lifting Columns, ensure that the maximum load for each
lifting column is not more than 13,200 lbs.
-Ensure that before use, the lifting system is placed vertically seen from the
sides as well as from the front.
-Make sure that the pallet jack mechanism is fully lowered before lifting a vehicle.
4.1 PREPARATION & IMPORTANT NOTICE
1. Place all the four of lifting columns around the vehicle as in Fig.8.
2. Ensure that the fork of each lifting column has been adjusted as in Fig.10
correctly
3. Move the columns’ forks under the wheel and lower the pallet jack.
4. Make sure that the Emergency Release buttons are unlocked on all the
lifting columns.
5. Set all the power switches to left position (ON). (Main column to be the last
one)
6. Press button START on the main control box to run the software.
7. Set the mode to be WHEEL / SINGLE.
Press the UP button to raise the fork of the column to touch the tire.
Repeat for other three columns.
8. If necessary, press BIAS to choose customized zero-point.
9. Set the mode to ALL / VEHICLE by pressing MODE button.