13
Harrier GTE -
Installation & Servicing
INSTALLATION
1
1
har5985
har5984
1
4
3
2
4
2
4
4
M12
M12
M12
16 POSITIONING THE REAR SECTION
1. Place the rear section in its
required position and support with
a wooden block.
2. Position the base frame up to the
rear section and insert the two
lower tie rods.
3. Slide the spacer over the rear end
of the threaded tie rod before
passing it through the rear section
4. Pass the rods through the rear
section and secure both ends with
the 4 washers and M12 nuts.
(This may be conducted after
preparing the section (Frame 17)
and fitting thermocord (Frame 18) if
preferred.)
17 PREPARING THE REAR SECTION
(This may be conducted before Frame 16 with the section laid flat
on the floor.)
1. Clean the nipple ports and nipples with kerosene/paraffin.
2. Coat the nipples with the coating material (linseed oil)
3. Push in the two nipples moderately.
4. Gently tap in the nipples using a wooden block to avoid
damage.
2
3
3
har5986
har5987
4
INST
ALLA
TION
For latest prices and delivery to your door visit MyTub Ltd - 0845 303 8383 - www.mytub.co.uk - [email protected]
