Ideal Clima KERS 25, Руководство пользователя и инсталлятора

Страница: 11 / 22

To use the remote control, put the switches in the middle position.
5.2 REMOTE CONTROLLER
The remote control works only if the buttons on board are both in an intermediate position.
The operating distance of the remote control can be affected by the environment in which it operates.
Possible operations with the remote control:
- "ON- OFF" button: turns the unit on and off. N. B. At each operation the remote control emits a “beep” to
check the battery charge. When pressed for about 10 seconds, up to a long BEEP, it interrupts the
acoustic signal emitted to remind you to clean the filters.
- "Night mode" button: The unit is equipped with a photo sensor which, when "Night mode" is on, changes
the fan speed according to the light conditions. To activate night mode, press the button once and wait
for confirmation with a long beep. To leave this mode, press the "Night mode" button a second time; the
change is signaled by a short beep. (Night mode is affected by the brightness of the environment)
- Speed selection button: three different buttons allow you to change the fan speed (and its flow rate).
The button with the darkest fan activates the highest speed, and vice versa.
- Passive ventilation button: allows you to open the fan shutter and let the air circulate naturally, without
activating the fan.
- Enter button: allows you to introduce fresh air into the rooms at the set speed. All the KERS connected in
series operate in input, regardless of the position of the jumper on terminal CN7.
- Extraction button: allows you to extract air from the rooms. The operating mode of all the KERS connected
in series is determined by the position of the jumper on terminal CN7.
- Heat recovery button: activates heat recovery. The unit operates for 65 seconds in injection and 65
seconds in extraction. The heat recovery unit exchanges energy between the outgoing and incoming
air. The jumper of the CN7 terminal synchronizes the KERS.
- Humidity control buttons: allows you to select three humidity levels (low, medium and high). Humidity
control is only possible in "heat recovery" mode. If the indoor humidity exceeds the predefined level, the
unit increases the speed. When the humidity drops below the set level, KERS reduces the speed. To
deactivate the command, press a button that selects the fan speed. The humidity control can only be
activated with the remote control.
Make sure that the remote control is properly powered before use (batteries charged, contacts free and
clean). The remote control works only in the absence of interference or external noise. The operating
range depends on the external conditions, on the charge level of the batteries, on the positioning with
respect to the machine.