Comfosplit IKARO HW
–
User and Installer manual
EN
© Ideal Clima - Page 47 of 68
15.4
PROGRAMMING WITH REMOTE CONTROL
Automatic
Press
ON / OFF
to turn on the hydronic terminal.
Press
MODE
to select (AUTO) on the display.
Press
SPEED
to select the fan speed (AUTO-LOW-MID-HIGH).
Press
ON / OFF
to turn off the hydronic terminal.
NB in the
AUTO
mode, it is not possible to select a temperature. This is why the display does not show it.
Cooling
Press
ON / OFF
to turn on the hydronic terminal.
Press
MODE
and select (COOLING) on the display.
Press
SET +/-
to adjust the temperature, in the field (16-32) ° C in increments of 1 ° C
Press
SPEED
to select the fan speed between (AUTO-MIDDLE-LOW-HIGH) on the display.
Press
ON / OFF
to stop the device.
Dehumidification
Press
ON / OFF
to turn on the hydronic terminal.
Press
MODE
and select (DRY) on the display.
Press
SET +/-
to adjust the temperature, in the field (16-32) ° C in increments of 1 ° C
Press
SPEED
to select the fan speed between (AUTO- MIDDLE -LOW-HIGH) on the display.
Press
ON / OFF
to stop the device.
Heating
Press
ON / OFF
to turn on the hydronic terminal.
Press
MODE
and select (HEAT) on the display.
Press
SET +/-
to adjust the temperature, in the field (16-32) ° C in increments of 1 ° C
Press
SPEED
to select the fan speed between (AUTO- MIDDLE -LOW-HIGH) on the display.
Press
ON / OFF
to stop the device.
Ventilation
Press
ON / OFF
to turn on the hydronic terminal.
Press
MODE
and select (FAN) on the display.
Press
SPEED
to select the fan speed between (AUTO- MIDDLE -LOW-HIGH) on the display.
Press
ON / OFF
to stop the device.
NB: In ventilation mode it is not possible to adjust the temperature setpoint and it does not appear on the
display.
Screen
Press
SCREEN
to turn on or off the on-board LCD display of IKARO HW. This display shows the temperature, or
error codes.
Machine Stop
Press
ON / OFF
: Remote display will read (OFF) and the unit will stop.
15.5
MODBUS RTU
Connect the RS 485 cable to the Modbus connector with three positions, that is lifting the lid.
NB: Dimension the termination resistor according to the selected network mice.
The device can be connected as a slave to a Modbus network with a baud rate of 9600 bps, 8 data bits, no
parity, 1 stop bit.
The default Modbus address is 15.
The following functions are available:
•
0x03: read holding register
•
0x04: read input register
•
0x10: write multiple registers
Содержание COMFOSPLIT IKARO
Страница 1: ...COMFOSPLIT IKARO HI WALL HW INVERTER 18 MANUALE PER L UTENTE E PER L INSTALLATORE ITALIANO...
Страница 35: ...Comfosplit IKARO HW Manuale per l utente e per l installatore IT Ideal Clima Pagina 35 di 68 11 NOTE...
Страница 36: ...IT Comfosplit IKARO HW Manuale per l utente e per l installatore Ideal Clima Pagina 36 68...
