Ideal Boilers Mexico Super RS 3/60P, Руководство по установке и обслуживанию

Страница: 24 / 40

24
Mexico Super RS 3/60P - 3/100P -
Installation
SERVICING
SER
VICING
1. Lift off the front door - Refer to
Frame 30.
2. Pull off the thermostat knob.
3. Remove the 2 screws and pull down
the control panel tabs clear of the
top panel.
4. Remove the thermostat phial from
the pocket - refer to Frame 30.
5. Remove the bottom self tapper and
remove the cover.
6. Remove the top screw and ease the
control box off the control panel.
7. Remove the 2 screws to release
the thermostat bracket.
8. Disconnect the electrical leads.
9. Unscrew the thermostat nut to
withdraw the thermostat.
10. Fit the new thermostat and re-
assemble in reverse order.
39 PILOT BURNER REPLACEMENT - RS 3/60P & RS 3/75P ONLY
1. Lift off front panel and remove the grille
assembly - refer to Frames 30 & 31.
Undo the gas cock union.
Remove the burner and controls assembly.
2. Remove the ignition electrode. Refer to
Frames 45.
3. Unscrew the thermocouple nut and pull the
thermocouple clear.
4. Undo the pilot supply pipe connection and
ease clear of the pilot burner. DO NOT lose
the pilot injector, which is a push-fit in the
pilot burner housing.
40 PILOT BURNER REPLACEMENT - RS 3/100P ONLY
1. Lift off front panel and remove the grille
assembly - refer to Frames 30 & 31.
Undo the gas cock union.
Remove the burner and controls
assembly.
2. Remove the ignition electrode. Refer
to Frame 46.
3. Unscrew the thermocouple
connection and pull the
thermocouple clear. Refer to Frame
48.
4. Undo the pilot supply pipe
connection and ease clear of the pilot
burner. DO NOT lose the pilot
injector, which is a push-fit in the
pilot burner housing.
5. Remove the 2 securing screws
and washers, and withdraw the
pilot burner.
6. Fit the new pilot burner and re-
assemble in reverse order,
ensuring that:
a. The injector is in position when
refitting the pilot supply.
b. A gas-tight joint is made.
c. The spark gap is correct. Refer
to Frame 46.
5. Remove the 2 securing screws
and washers, and withdraw the
pilot burner.
6. Fit the new pilot burner and re-
assemble in reverse order,
ensuring that:
a. The injector is in position when
refitting the pilot supply.
b. A gas-tight joint is made.
c. The spark gap is correct. Refer
to Frame 45.
41 CONTROL THERMOSTAT REPLACEMENT