ADS-RR(SR)-HK3-DS-IG-EN
maestro.idatalink.com
Kia sedona naviGation radio, witHout aMp 2019-2020
Automotive Data Solutions Inc. © 2021
6
TROUBLESHOOTING TABLE
PROBLEM
SOLUTION
Gauges do not work, radio shows OBD2 Error 1 or Error 2.
Ensure the 2 pin
BLACK
connector with the
BROWN/YELLOW
and
BROWN/
RED
wires is connected to the mating
BLACK
2 pin connecto coming off the
OBDII harness and check for any terminals that may have been pushed out
when connecting the two.
Make sure the colors line up at the
BLACK
2 pin connectors;
BROWN/
YELLOW
should line up with
YELLOW
and
BROWN/RED
should line up with
RED
.
Make sure the OBDII connector is seated properly on the OBDII connector of
the vehicle.
If you hardwired the connections at the OBDII, check the connections at the
OBDII connector. Make sure the
RED
wire is on PIN 6 and the
YELLOW
wire
is connected to PIN 14 of the OBDII connector.
Do not use T-Taps.
Soldering or military splicing methods are recommended.
If the vehicle has anything plugged into the OBDII connector the Maestro RR2
will not read the vehicle information until what was connected is removed.
Reset the RR2.
Cannot hear a caller but they can hear me.
Make sure the RCA cables coming from the ACC-RR-SPDIF are plugged into
the FRONT RCA outputs of the radio.
The light on the Maestro is blinking
RED TWICE
.
Ensure the 4-pin data cable is connected between the radio and the RR2 in
the correct location (on the RR2 the Data cable plugs into the BLACK 4 pin
port),
Make sure the correct radio model and serial number were entered during
the fl ash. Verify the radio’s serial number entered during the fl ash matches
what is listed on the radio info screen. This can be found in the settings of
the radio, listed as Device Id, Device Number, or Serial Number.
Make sure the radio is powering up.
The light on the Maestro is fl ashing
RED ONCE
.
There is no fi rmware on the module; fl ash the RR2 module.
MAESTRO RR2 RESET PROCEDURE:
Turn the key to the OFF position, then disconnect all connectors from the module.
Press and hold the module’s programming button and connect all the connectors back to the module. Wait, the module’s LED will fl ash RED rapidly (this may
take up to 10 seconds).
Release the programming button. Wait, the LED will turn solid GREEN for 2 seconds to show the reset was successful.
TECHNICAL ASSISTANCE
Phone: 1-866-427-2999
Email: [email protected]
Web: maestro.idatalink.com/support add www.12voltdata.com/forum/
IMPORTANT: To ensure proper operation, the aftermarket radio needs to have the latest fi rmware from the manufacturer. Please visit the radio
manufacturer’s website and look for any updates pertaining to your radio.
