Manual IB-1807MT-C31
Usage
•
Connect the USB cable with the sole Type-C
®
connector to the M.2 enclosure
•
Connect the Type-C
®
or Type-A adapter of the USB combo cable to your host
computer
•
Once the IB-1807MT-C31 has been plugged in correctly the LED lights up white!
•
The external enclosure can be connected or disconnected while the computer
is running.
•
Please await the end of read/write operations before disconnecting the device
to avoid data loss.
•
A new SSD must first be initialised, partitioned and formatted by the operation
system to be displayed by the system.
•
If the drive is not recognised instantly by the operating system, please check:
o
if the driver software is installed (USB)
o
if the SSD is initialised, partitioned and formatted
•
The full USB 3.2 (Gen 2)* transfer rate of up to 10 Gbit/s can only be achieved
with a compatible USB 3.2 (Gen 2)* port on your host computer.
*USB 3.2 (Gen 2) corresponds to USB 3.1 and USB 3.1 (Gen 2)
Write protection:
•
As soon as the write protection has been activated by switch, the LED lights up red!
ATTENTION
! A change of the write protect mode only takes effect if the device
has been disconnected and then reconnected to the host computer.