If you have any questions, please call 1-800-558-4435
ICWUSA.com, Inc.
If you have any questions, please call 1-800-558-4435
ICWUSA.com, Inc.
Page 5 of 5
VT21 insTallaTion
VT21 INSTALLATION - rev 10/6/15 pjm
aTTaCH TRaCK aDaPTERs
•
Attach track adapters to
back of wall ear by
threading socket head
screws from front of ear
into track adapters.
Loosely tighten with
3/16” hex key.
•
Slide track adapters into track
from either top or bottom.
Position to desired location on
track. Firmly tighten screws
with 3/16” hex key.
Wall ear
WiRE ManaGEMEnT
•
After arm mounting is
complete, pull slack wire
down and run through
center of track.
•
Snap track cover into
place.
•
Replace plastic end cap.
VTTM onlY - sECURE MoniToR
To attach monitor
more securely,
back screws out
slightly so the ball
VESA drops down
completely into
the keyhole slots.
Retighten screws.
Screws on back of ball VESA
are factory set to wedge fit into
keyhole slots on face plate.
VTTM onlY - aTTaCH
Wall EaRs To Wall
Locate the wall stud and mark
the top hole of the Wall Ear. Drill
a 11/64 pilot hole, insert a #14
screw and tighten slightly. Using
a level, mark the lower holes, drill
pilot holes and then insert the #14
screws and tighten.
IF ATTACHINg VTTM DIrECTLY TO WALL
