Page 1
If you have any questions, please call 1-800-558-4435
ICWUSA.com, Inc.
VT21 insTallaTion
VT21 INSTALLATION - rev 10/6/15 pjm
Page 1 of 5
VTTM Tandem arm
Uses Ball VESA
MAXIMUM LOAD CAPACITY
10- 25 Lbs (4.5-11.3 kg)
all MoDEls - aTTaCH FaCE PlaTE
Attach face plate to
slider assembly with
.25-20x1.25 flat head
screws.
VTTM onlY - aTTaCH aRMs
Loosen factory installed
screw in each side of
arm assembly. Rotate
arms into position as
shown. Tighten existing
screw. Insert 3 additional
screws into both short
ears. Tighten.
4 screws on each side
.25-20x.625
VTTM onlY - aTTaCH MoUnTinG PlaTE
To attach main unit
to arm assembly,
insert .25-20x1.25
flat head screws
through top and
bottom holes of
front of main
assembly into
mounting plate.
Insert three .25-
20x.25 button head
screws in center
holes through front
of main unit. Tighten
screws.
Mounting
plate
Button
head
screws
VT & VTlP - MoUnT Main assEMBlY
Locate the wall stud and mark
the top hole. Using a level,
mark the lower hole. Drill 11/64
pilot holes and insert #14
screws through the front of
main assembly and tighten.
NOTE:
#14 Wood screws are
supplied with unit. If installing
into
metal studs
, you will
need to replace these with
proper metal stud fasteners. All
hardware used to secure track
mount must have a proper
countersunk head.
VT
Uses Ball VESA
VTlP low P
rofile
Uses Flat VESA
All models are available with
Flip-up keyboard Tray or
Worksurface Tray.
VTTM onlY-
MoUnTinG
To Wall oR
Wall TRaCK
Instructions
on page 4
VIDEO: Installation
https://youtu.be/PJwD1749kQc
VIDEO: Wire management
https://youtu.be/wBgJh0AiDMI
